Ethereal-users: RE: [Ethereal-users] Help with error message
Note: This archive is from the project's previous web site, ethereal.com. This list is no longer active.
Hi,
Best
regards
Anders
Thanks,
I removed the previous version and
installed ethereal-setup-20040923173601.exe
, after that the program starts normally, but when I try to start a capture I get another error "file capture-wpcap.c: line 278: assertion failed: (has_wpcap && p_pcap_datalink_val_to_name != NULL) aborting..."
Bruce Rainwater
At 01:55 AM 9/28/2004, you wrote:
Hi,
You might want to try the
pre release, where some known errors are fixed.
http://www.ethereal.com/distribution/prerelease/
Best
regards
Anders
-----Original Message-----
From:
ethereal-users-bounces@xxxxxxxxxxxx
[mailto:ethereal-users-bounces@xxxxxxxxxxxx]On Behalf Of
James A.
Alinsky
Sent: den 27 september 2004 18:09
To:
ethereal-users@xxxxxxxxxxxx
Subject: [Ethereal-users] Help with error
message
Hi,
I am new to Ethereal and have downloaded
0.10.6 and WinPcap 3.0.
Installation on a Compaq laptop
under Windows Me was uneventful.
However, on starting Ethereal, the
banner says "Registering
dissectors.." and then an error message
appears:
"Ethereral has caused an error in LIBGLIB-2.0-0.DLL.
Ethereal will
close now."
Re-booting and repeat attempts to run
Ethereal lead to the same error
message.
Any ideas? Thanks
for any help you can offer.
Jim
Alinsky
_______________________________________________
Ethereal-users
mailing list
Ethereal-users@xxxxxxxxxxxx
http://www.ethereal.com/mailman/listinfo/ethereal-users
_______________________________________________
Ethereal-users
mailing list
Ethereal-users@xxxxxxxxxxxx
http://www.ethereal.com/mailman/listinfo/ethereal-users