I use now a Prism2 card (Compaq WL100) with the wlan-ng driver.
I use the following command to put the card in rfmon:
wlanctl-ng wlan0 lnxreq_wlansniff channel=[#channel i want to analyse] enable=true wlanheader=true and then I run ethereal
...and it looks like i still do not get control frames as I should.
is this command ok?Is there another way to put the card in monitor mode? or..?
-Laurent
Joshua Wright <jwright@xxxxxxxxxxx> wrote:
Laurent,
P Laurent wrote:
> I am a student begynner with Ethereal and wlan monitoring under Linux
> (Mandrake 10). I manage to capture management (mainly beacon) and
> data frames on a 802.11b network but no control frame. Has anyone
> already experienced this problem and eventually found a solution?
Some drivers and/or card firmware will not pass the control frames to
libpcap for processing. I know that the orinoco_cs drivers will report
everything but control frames while in RFMON, while the wlan-ng and
hostap drivers will report both management and control frames.
Not sure about the Cisco drivers, but if you really want control frames,
I'd go with a Prism2 wireless card and the wlan-ng drivers.
-Josh
--
-Joshua Wright
jwright@xxxxxxxxxxx
http://home.jwu.edu/jwright/
pgpkey:
http://home.jwu.edu/jwright/pgpkey.htm
fingerprint: FDA5 12FC F391 3740 E0AE BDB6 8FE2 FC0A D44B 4A73
_______________________________________________
Ethereal-users mailing list
Ethereal-users@xxxxxxxxxxxx
http://www.ethereal.com/mailman/listinfo/ethereal-users
Cr�ez gratuitement votre Yahoo! Mail avec
100 Mo de stockage !
Cr�ez votre Yahoo! Mail
Le nouveau Yahoo! Messenger est arriv� ! D�couvrez toutes les nouveaut�s pour dialoguer instantan�ment avec vos amis.
T�l�chargez GRATUITEMENT ici !