Ethereal-users: [Ethereal-users] RECALL - Linux 7.3 - PCMCIA Cisco 350 ap and Ethereal

Note: This archive is from the project's previous web site, ethereal.com. This list is no longer active.

Date Prev · Date Next · Thread Prev · Thread Next
Date Index · Thread Index · Other Months · All Mailing Lists
From: Ian Johnson <ian.johnson@xxxxxxxxxxxxxxxxx>
Date: Tue, 5 Nov 2002 17:25:35 +1100 
Sorry for any inconvenience, I have resolved the problem, I had two
interfaces with the same name.

Ian Johnson

> -----Original Message-----
> From:	Ian Johnson 
> Sent:	Tuesday, 5 November 2002 4:49 PM
> To:	'ethereal-users@xxxxxxxxxxxx'
> Subject:	Linux 7.3 - PCMCIA Cisco 350 ap and Ethereal
> 
> Hi,
> 
> I need some help in configuring Ethereal/Linux to run on my Compaq laptop.
> 
> Linux 7.3 has recognised the card, a Cisco PCMCIA 350 series ap, I have
> installed the Cisco drivers and the Cisco ACU software and all this has
> worked well and I can associate to nodes.
> 
> However I want to run Ethereal, I have installed the RPM's, I can start
> the program but I cannot see the interface which should be eth2 which is
> what was designated during the Cisco driver install.
> 
> I have tried in user and root mode with no luck, I think that I need to
> tell Linux about the device but I am not sure how.
> 
> any help or direction appreciated, thanks
> 
> Ian Johnson
>