VERY NICE!
Can you add a print button in the top right corner (I have always wanted one
of those but never found time
to add it) so one can print it to either file or printer?
Most of the time, I look at TCP conversations, is it possible to either
configure which tab should be the default one
or make it remember the last one i looked at?
Can you also add a filter box to the window, just above the table, this is
another thing i have always wanted but never found time for.
Very nice.
----- Original Message -----
From: Ulf Lamping
To: Ethereal-Dev
Sent: Sunday, May 02, 2004 7:16 PM
Subject: [Ethereal-dev] [RFC] Combined dialogs for the
differentconversations types
Hi List!
I'm often have TCP or UDP traffic that I like to investigate.
Currently I find it difficult to use the conversation dialogs, as there is
no good way to "navigate" through the dialogs (must open / close a lot of
them), to get an idea of the conversation relations.
Instead of opening/closing a lot of single dialogs, it would be much easier
to have a single conversation dialog, with notebook tabs for the different
conversation types (Ether, IP, UDP, TCP, ...).
I've tried to implement this to some extent, but didn't currently check it
in. I would like to hear from others, if this is the right way to go, before
(slightly) changing all the endpoint_talkers_xy and a lot of other files.
Here is a screenshot of my investigations so far:
Of course, some of the conversation types (FDDI, ...) are missing, but that
can be easily added.
To access this, a new menu item "Conversations" just below the current item
"Statistics/Protocol Hierarchy" would be appropriate.
Completely the same applies to the "Endpoint lists" too, but I didn't
started working on that topic.
Any comments?
Regards, ULFL
_______________________________________________
Ethereal-dev mailing list
Ethereal-dev@xxxxxxxxxxxx
http://www.ethereal.com/mailman/listinfo/ethereal-dev