On Tue, 2 Dec 2003, Eichert, Diana wrote:
> looking at
> http://www.ethereal.com/cgi-bin/viewcvs.cgi/ethereal/doc/tethereal.pod?rev=1
> .9&content-type=text/vnd.viewcvs-markup
Hmmm, OK, my man pages were seriously out of date.
> =item -q
>
> Don't display the continuous count of packets captured that is normally
> shown when saving a capture to a file; instead, just display, at the end
> of the capture, a count of packets captured. On systems that support
> the SIGINFO signal, such as various BSDs, typing your "status" character
> (typically control-T) will cause the current count to be displayed.
>
> -----Original Message-----
> From: Richard Sharpe
> To: ethereal-dev@xxxxxxxxxxxx
> Sent: 12/2/2003 10:50 PM
> Subject: [Ethereal-dev] The -q arg to tethereal seems not to be documented
> in the man page
>
>
> Regards
> -----
> Richard Sharpe, rsharpe[at]ns.aus.com, rsharpe[at]samba.org,
> sharpe[at]ethereal.com, http://www.richardsharpe.com
>
> _______________________________________________
> Ethereal-dev mailing list
> Ethereal-dev@xxxxxxxxxxxx
> http://www.ethereal.com/mailman/listinfo/ethereal-dev
>
> _______________________________________________
> Ethereal-dev mailing list
> Ethereal-dev@xxxxxxxxxxxx
> http://www.ethereal.com/mailman/listinfo/ethereal-dev
>
--
Regards
-----
Richard Sharpe, rsharpe[at]ns.aus.com, rsharpe[at]samba.org,
sharpe[at]ethereal.com, http://www.richardsharpe.com