Ethereal-dev: RE: [Ethereal-dev] The -q arg to tethereal seems not to be docume nted in the ma

Note: This archive is from the project's previous web site, ethereal.com. This list is no longer active.

Date Prev · Date Next · Thread Prev · Thread Next
Date Index · Thread Index · Other Months · All Mailing Lists
From: "Eichert, Diana" <deicher@xxxxxxxxxx>
Date: Tue, 2 Dec 2003 21:53:00 -0700
looking at
http://www.ethereal.com/cgi-bin/viewcvs.cgi/ethereal/doc/tethereal.pod?rev=1
.9&content-type=text/vnd.viewcvs-markup

=item -q

Don't display the continuous count of packets captured that is normally
shown when saving a capture to a file; instead, just display, at the end
of the capture, a count of packets captured.  On systems that support
the SIGINFO signal, such as various BSDs, typing your "status" character
(typically control-T) will cause the current count to be displayed.

-----Original Message-----
From: Richard Sharpe
To: ethereal-dev@xxxxxxxxxxxx
Sent: 12/2/2003 10:50 PM
Subject: [Ethereal-dev] The -q arg to tethereal seems not to be documented
in the man page

 
Regards
-----
Richard Sharpe, rsharpe[at]ns.aus.com, rsharpe[at]samba.org, 
sharpe[at]ethereal.com, http://www.richardsharpe.com

_______________________________________________
Ethereal-dev mailing list
Ethereal-dev@xxxxxxxxxxxx
http://www.ethereal.com/mailman/listinfo/ethereal-dev