Hi Nilo,
----- Original Message -----
From: "Nilo Rivera"
Subject: [Ethereal-dev] SDL/HSD RS-232/V.35/etc Capture and Complete 7 Layer
OSI for Ethereal
> Hi all
>
> I just started using Ethereal and Im amazed with this product. It is
> comparable and in some ways better than the 4 different analyzers that
> I have. Im interested in joining ethereal's developement effort!
Thank you. We also think ethereal is good.
You are welcome to join and contribute to make ethereal even better.
>
> First: Is there a way to capture from the COM/Serial port in a PC? If
> not, has it been discussed? My point is that most telecommunication
> WANs use RS-232/RS-449/V.35/etc using HDLC (lapb, etc) protocol. This
> way all could be done from a laptop, a Y cable and the proper converter
> if necessary. (Im not sure of speed limits / limitations of the com
> port and if this makes scence). Even further, would Ethereal work with
> the proper pcmcia/usb/... device like:
> http://www.sealevel.com/catalog/pcmciab.htm
It is just software, so anything is possible.
usb and similar are discussed from time to time but has not been implemented
yet.
it would need support from the underlying os to allow capturing on these
interfaces.
Serial data would be interesting.
I guess it would require a dissector that would take one byte at a time from
the serial device
and then when it had detected a full (how does it do this?) upper layer
packet, then the entire
packet is pushed to higher layers.
I dont think it would be difficult at all to start with but the only
problem would be to teach it to identify different types of framing/packets
by looking at the
byte stream and how to identify and recover from lost bytes.
Another thing which would be problematic but I guess could be ignored to
start with
would be the signalling. ie the 104/105 etc signals. Since this would be
very different to extract from the device
depending on which link you use I think one should ignore it to start with.
Make it generic enough so that we could also use it to drop HDLC data from
timeslots in an e1/t1
for if/whenever we will start supporting those cards.
This would probably need some major infrastructure to be added to ethereal
before it is feasible.
>
> Second: I see x.25 and ISO 8073 COTP (CCITT/ITU x.224) implemented.
> Has there been any plans to fully implement the complete OSI stack
> (ISO 7498 or ITU x.200). Is not widely used, but is used...specially
> for FTAM transfers. Im interested in adding this with time if no one
> is working on it already, or help out. What do you think? Is it worth
> the effort? The protocols that would need to be added are:
>
> ISO 8327 Session Protocol ( CCITT / ITU x.225 )
> ISO 8823 Presentation Protocol ( CCITT / ITU x.226 )
> ISO 8650 ACSE( CCITT / ITU x.227 )
> Maybe a subset of FTAM after these
>
This sounds great.
It would definitely be worth the effort.
>
> Thanks a lot,
> Nilo
>
> _______________________________________________
> Ethereal-dev mailing list
> Ethereal-dev@xxxxxxxxxxxx
> http://www.ethereal.com/mailman/listinfo/ethereal-dev