[karthick saravanan <karthicksarav@xxxxxxxxx>]

Hello,

 I am trying to capture wireshark using "remote interface" for a polycom phone. But this has to be done using the command line and not manually launching wireshark gui followed by "remote interface" config.

Hence, I would like to know how to pass the remote interface and username password for a polycom phone. Kindly let us know.

tshark.exe -i rpcap://example.com/eth0 

I observed that the "-z" option is not the right one for my requirement and hence how to pass username/password in the above command line for a phone?

Regards,

Karthick