[damker <damker@xxxxxxxx>]

my version was 3.0.6.

when i upgrade to 3.0.11, it shows like this "Fragment offset: 856".

---

damker

 

发件人： Jaap Keuter

发送时间： 2020-06-19 23:10

收件人： Community support list for Wireshark

主题： Re: [Wireshark-users]the Fragment offset field in IP packet should follow the Raw bitstream？

That was a nice bit of source code archeology, but I’ve found that this format was changed in commit 7f6d5c04a86 with the comment:

commit 7f6d5c04a869525d31e8d6e260d5195857481031
Author: Martin Mathieson <martin.r.mathieson@xxxxxxxxxxxxxx>
Date:   Wed Aug 29 15:35:27 2007 +0000

    Don't show fragment offset as a bit field, but note number of bits used in long text.
    
    svn path=/trunk/; revision=22727

Note the date, that was back in 2007, so this format disappeared before Wireshark 1.0.

Where did you get this from?

Thanks,

Jaap

On 19 Jun 2020, at 09:48, damker <damker@xxxxxxxx> wrote:

an IP packet decode As follows:

    ...

    Flags: 0x006b
        0... .... .... .... = Reserved bit: Not set
        .0.. .... .... .... = Don't fragment: Not set
        ..0. .... .... .... = More fragments: Not set
    ...0 0011 0101 1000 = Fragment offset: 856
    Time to live: 128

I know that it says "The fragment offset is measured in units of 8 octets (64 bits)" in RFC 791.

my question is: Flags = 0x006b, the "...0 0011 0101 1000 = Fragment offset: 856" should be "...0 0000 0110 1011 = Fragment offset: 856"?

I think the second one is more clear.

---

damker

 

___________________________________________________________________________
Sent via:    Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
Archives:    https://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://www.wireshark.org/mailman/options/wireshark-users
            mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe