Is there a write-up somewhere showing which protocols should be
enabled for different scenarios?
I did a capture & the source picked tcp port 4556 for sending so
wireshark decides it's "tcp bundle" protocol and displays much
garbage.
Analyze / Enabled Protocols
remove the checkmark next to Bundle
click on Save
and garbage goes away :) But while I was there I noticed about 500
lines of Bluetooth GATT protocols; I'm guessing that I'm not going to
be looking at any bluetooth anything, so _way_ too many clicks later
all that is turned off. Any recommendations on what else should be
turned off?
Thanks,
Lee