[NITIN GOYAL <nitinkumgoyal@xxxxxxxxx>]

If you are doing RTSP/RTP stream, data will be RTP over UDP.

Check where your actual data is coming over which protocol. Then you can make the filter. There are ways where you can calculate the jitter values etc for that data. Also, I have said for jitter etc there is already an analyser in Wireshark which do all that.

On Thu, Nov 20, 2014 at 6:56 PM, Oriplatform Dp <oriplatform85@xxxxxxxxx> wrote:

Thanks for your reply,

Actually, I want these parameters and I ask to this mailing list because I'm not get them.

I have about 4 files (.pcapng) each scenario.

I'm confused about TCP, UDP, or both are unrelated.

In the scenario 1, the list of protocols in the wireshark are 

ARP

ICMP

OLSR V1

TCP (the most)

UDP

in the scenario 2, they are

ARP

ICMP

OLSR V1

RTP (the most)

UDP

regards

 

On Tuesday, November 18, 2014 4:43 PM, NITIN GOYAL <nitinkumgoyal@xxxxxxxxx> wrote:

On Mon, Nov 17, 2014 at 10:17 PM, Oriplatform Dp <oriplatform85@xxxxxxxxx> wrote:

I'm looking for the value of this parameter in wireshark:

end-to-end delay, throughput, packet loss, and jitter.

I've done a couple of scenarios.

1. I send a file from one node (192.168.100.1) to another node (192.168.100.6) using file transfer software in the LAN.

2. I'm broadcasting (192.168.100.1) video via VLC using RTSP protocol and the one of the other node (192.168.100.6) streams that video.

Your question is not clear. You want these parameters or you are not getting them? If the media or dat is sent over RTP with RTSP, there is one RTP analyser which will give all of these params.