On 12/12/2012 9:59 AM, kurt.jensen@xxxxxxxxxxxxxxx wrote:
Just installed Wireshark and started capture. Plugged in our GigE camera
under development. Connected and collected a frame of data.
Wireshark shows all of the GVCP requests and answers. Very nice! But I
am not seeing any of the UDP data. I have no filters set, just selected
the interface then slicked start. I have run Wireshark before on another
computer where the UDP data just showed up along with the GVCP packets.
I know the data is there because my PC app displays the image. But not
in Wireshark.
How do I get the UDP data?
Kurt
I'm not sure I understand.
It appears that GVCP is carried over UDP so it sounds like you are
saying that only certain UDP frames are missing.
Is the "data" carried over the GVCP protocol ?
If so, I would expect the data show up as being under the GVCP layer of
the protocol tree (as opposed to the frames just showing as UDP.
IOW: the "protocol" column would show GVCP as opposed to UDP.
(I've no knowledge of the GVCP protocol so I may be off-base).
Bill