[Tihomir Plachkov <tihomir.plachkov@xxxxxxxxx>]

Here is some more info. Do I stand a chance to enter monitor mode with the wl0 driver and this card?. I found some more info which I am going to explore further but I also want to consider your opinion.

http://www.willhackforsushi.com/books/377_eth_2e_06.pdf

Excuse my unexperience with the matter, I am trying to get the pieces together so it will make sense at one point.

Thanks
Tish

 

lspci
 Network controller: Broadcom Corporation BCM4312 802.11b/g (rev 01)

:/$ sudo lshw -C network
          *-network
       description: Wireless interface
       product: BCM4312 802.11b/g
       vendor: Broadcom Corporation
       physical id: 0
       bus info: pci@0000:0b:00.0
       logical name: eth1
       version: 01
       serial: 00:22:5f:46:15:5a
       width: 64 bits
       clock: 33MHz
       capabilities: pm msi pciexpress bus_master cap_list ethernet physical wireless
       configuration: broadcast=yes driver=wl0 driverversion=5.60.48.36 ip=192.168.1.4 latency=0 multicast=yes wireless=IEEE 802.11bg
       resources: irq:17 memory:f1efc000-f1efffff

On 1 December 2010 17:51, Stephen Fisher <steve@xxxxxxxxxxxxxxxxxx> wrote:

On Wed, Dec 01, 2010 at 12:04:04PM +0100, Tihomir Plachkov wrote:

> I start wireshark with administrative previliges to put the interface
> in promiscous mode(sudo wireshark) but untill now I can see the
> packets regarding 'machine' only what came from my side 192.168.1.2
> (pings, traceroutes etc.) .

Wireless cards often do not show traffic not destined for them.  See
http://wiki.wireshark.org/CaptureSetup/WLAN for more details.

___________________________________________________________________________
Sent via:    Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
Archives:    http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
            mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe