["Lori" <Verdandi@xxxxxxxxxxxxxxxxxx>]

Title: How do I change the default capture filter?

If you click on Help  |  About Wireshark and go to the Folders tab, it will show you the path for both Global and Personal configurations.

 

Hope this helps.

 

Lori

 

----- Original Message -----

From: Bland, Alan

To: wireshark-users@xxxxxxxxxxxxx

Sent: Thursday, August 06, 2009 2:10 PM

Subject: [Wireshark-users] How do I change the default capture filter?

At some time in the past I created a filter and managed to set it as the default filter, because every time I start Wireshark and start a capture that filter is shown in the "capture filter" text box.

This is a problem because I deleted the filter, so it is not found.

How do I remove this default setting.

To fix it I resorted to uninstalling wire shark (1.0.7) and reinstalled it.  The default filter was the non-existent filter.

I uninstalled wireshark and install ethereal (0.99).  The default filter was still the non-existent filter.
I uninstalled ethereal and installed wireshark (2.0 the July 2009 release).  The default capture filter was still the non-existent filter.

I scanned the registry for the name of the filter.  Not found.
I searched the entire C: drive looking for the filter by name.  Not found.

This is like a spirit from the other side that has not found peace and cannot rest.

Your help is needed.  How do I remove this setting?

---

___________________________________________________________________________
Sent via:    Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
Archives:    http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
             mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe