Hi Kray
See the section about export DISPLAY=:0.0 on this page...
http://trac.macosforge.org/projects/macports/wiki/InstallingMacPorts
Mike
On Jan 29, 2007, at 12:00 PM, Kray Mitchell wrote:
I am fully new to all this, but I instlaled Wireshark today (full
install) and I already have X11 installed. I am trying to run ANYTHING
in wireshark and I get this error
(wireshark:550): Gtk-WARNING **: cannot open display:
Though the number changes depending on what I try and run. I can get
wireshark -h to work, but that is it, and it is not very helpful to
me.
I am just trying to find something so I can find out what is happening
on the network, so I can start learning to find out where bottlenecks
are happening so I can figure out a solution.
Thanks
kray
_______________________________________________
Wireshark-users mailing list
Wireshark-users@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-users