I have found that I can reconnect to my wireless access point after I
start the trace, and all works as expected (until the next trace, at
which time you see the problem again). The only other workaround I
have found is to run the capture from the command line, and then use
wireshark to decode the capture file for you. For example...
sudo tcpdump -i en1 -s0 -w qq.cap dst port 80
wireshark qq.cap
On Nov 23, 2006, at 1:00 PM, Robert Craig wrote:
I have just installed wireshark on my intel duo MacBook using
DarwinPorts.
It starts up fine (as root) but as soon as I click "List available
capture interfaces..." my wireless disconnects and refuses to
reconnect whilst wireshark is open.
Although it works fine for the wired network.
Any suggestions?
Thanks in advance