Different vendors label this action different things:
SPAN Port
Mirror Port
Monitor Port
My Cisco 4510R statement goes like this; your syntax may vary; and all
commands listed below are given from the Executive mode:
monitor session 1 source interface G4/10
monitor session 1 destination interface G5/10
[where source is the interface I wish to capture from;
where destination is the interface I have plugged into with WireShark]
show monitor session 1 (all)
no monitor session 1
Craig Wicker
Hooker Furniture Corp
Network Administrator
-----Original Message-----
From: wireshark-users-bounces@xxxxxxxxxxxxx
[mailto:wireshark-users-bounces@xxxxxxxxxxxxx] On Behalf Of Nathan J.
Churchill
Sent: Tuesday, August 29, 2006 3:01 PM
To: wireshark-users@xxxxxxxxxxxxx
Subject: [Wireshark-users] Using with a switch
Hello:
Our network runs with a switch. Can Wireshark pick up all the connected
stations? I'm only seeing my own machine's traffic now. Can that be
changed? If so, how?
Thanks.
Regards,
Nathan
_______________________________________________
Wireshark-users mailing list
Wireshark-users@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-users