[Alexis La Goutte <alexis.lagoutte@xxxxxxxxx>]

if you go on Projets => General => Wireshark

You have the list of URL (SSH / HTTPS)

and it is :
git clone https://USERNAME@xxxxxxxxxxxxxxxxxx/review/wireshark

for http(s)

Regards,

On Mon, Nov 30, 2015 at 12:11 PM, Graham Bloice <graham.bloice@xxxxxxxxxxxxx> wrote:

On 30 November 2015 at 10:58, Paul Offord <Paul.Offord@xxxxxxxxxxxx> wrote:

Hi Graham,

 

OK – I’ve tried all of the changes below but still no joy.  So, how do I do this with HTTPS connections instead?  I’ve tried:

 

C:\Development\Wireshark>git remote set-url origin https://code.wireshark.org/USERNAME/wireshark

 

but that doesn’t work.  If I try this URL through a browser it just throws a 404 Page not found.

 

Thanks and regards…Paul

 

 

Hi Paul,

Unfortunately I've never run git over http(s), so have no advice to offer.  I suggest you continue without the luxury of git-review for the moment.

Googling for Gerrit push over https found this link: https://www.mediawiki.org/wiki/Gerrit/Tutorial#Push_using_HTTPS, not sure if that's relevant though.

--

Graham Bloice

___________________________________________________________________________
Sent via:    Wireshark-dev mailing list <wireshark-dev@xxxxxxxxxxxxx>
Archives:    https://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
             mailto:wireshark-dev-request@xxxxxxxxxxxxx?subject=unsubscribe