Le 28 avr. 2014 00:06, "Richard Sharpe" <realrichardsharpe@xxxxxxxxx> a écrit :
>
> On Sun, Apr 27, 2014 at 1:41 PM, Richard Sharpe
> <realrichardsharpe@xxxxxxxxx> wrote:
> > On Sun, Apr 27, 2014 at 1:07 PM, Richard Sharpe
> > <realrichardsharpe@xxxxxxxxx> wrote:
> >> On Sun, Apr 27, 2014 at 12:58 PM, Richard Sharpe
> >> <realrichardsharpe@xxxxxxxxx> wrote:
> >>> On Sun, Apr 27, 2014 at 12:49 PM, Richard Sharpe
> >>> <realrichardsharpe@xxxxxxxxx> wrote:
> >>>> On Sun, Apr 27, 2014 at 12:38 PM, Pascal Quantin
> >>>> <pascal.quantin@xxxxxxxxx> wrote:
> >>>>> MSVC2013 comes with a x64 compiler so you should directly call vcvarsall.bat
> >>>>> with the x64 parameter, and not call SetEnv.Cmd from the 7.1 SDK.
> >>>>
> >>>> Ahhh, that sounds reasonable. I got past the original problem, but
> >>>> then ran into a problem where SetEnv.Cmd was overriding the INCLUDE
> >>>> path to something that did not exist.
> >>>>
> >>>> Hmmm, but then I run into problems where win32.mak is not found.
> >>>
> >>> Got much further after following the hint here:
> >>>
> >>> http://ask.wireshark.org/questions/4725/file-win32mak-not-found-stop
> >>>
> >>> Now have a problem with Bison, m4 subprocess failed.
> >>
> >> OK, got much further after installing m4 for Cygwin ... almost there ...
> >
> > So, now I am stuck on the unresolved externals wrt ett_nds.
> >
> > I have installed the native Win32 version of Python, but that does not
> > seem to have prevented this problem.
>
> Something went wrong with epan\dissectors\packet-ncp.c etc, but after
> checking them out again and rebuilding, I seem to have a
> wireshark.exe.
>
> However, now I get "The program failed to start because
> wiretap-1.11.0.dll is missing ..."
>
> Now. to figure out what to do.
Launch the executable from the wireshark-gtk2 folder.