Hi, Divya.
You'll want to run ./wireshark in the directory that you've built it
in. It should then launch, if it was built fully.
Tyson.
On Wed, Aug 12, 2009 at 5:15 PM, divya
kothapally<kdivyareddy166@xxxxxxxxx> wrote:
>
> Hello,
> Iam trying to launch wireshark by just doing a make on it. It is giving me
> following errors:
> gcc: sync_pipe_write.o: No such file or directory
> gcc: util.o: No such file or directory
> gcc: tap-rtp-common.o: No such file or directory
> gcc: capture_info.o: No such file or directory
> gcc: epan/.libs/libwireshark.so: No such file or directory
>
> Is there any way that i could launch the wireshark without doing a make
> install after make ?
> --
> Best,
> Divya Kothapally
>
> ___________________________________________________________________________
> Sent via: Wireshark-dev mailing list <wireshark-dev@xxxxxxxxxxxxx>
> Archives: http://www.wireshark.org/lists/wireshark-dev
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-dev
> mailto:wireshark-dev-request@xxxxxxxxxxxxx?subject=unsubscribe
>
--
Fight Internet Censorship! http://www.eff.org
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
http://i9.house404.co.uk/ | Twitter/FriendFeed/Skype: vmlemon | +447549728105