Hi all,
I want to turn off the optimization and enable the debugging symbols
while compiling wireshark;
I have tried the following, but with no luck. Can someone point me in
the right direction?
I obtained the wireshark tar file; untarred it and ran the following:
1. ./autogen.sh
2. Set the environment flags:
CXXFLAGS=-g -O0
./configure
3. make
I then, tried to start wireshark from the epan/dissectors location
using ddd with the compiled wireshark. However, whenever I try to open
the source file of say either existing dissectors or our custom
plugins, it always complains about Line 1 of "packet-xxx.c" is at
address 0x31f8d70 <check_mask> but contains no code.
Also, for some of the values, it says, "optimized out".
Can someone point me in the right direction to debug wireshark
dissectors/plugins? I am assuming that the above is because of the
optimization flag. Are there any other flags that I need to set?
Thanks in advance,