Hi,
I am using Microsoft Visual 2008 : winXP
I have added a small plug-in but when I
start Wireshark.exe it crashes with a fault address in libwireshark.dll.
I am 75% sure this is due to my plug-in
(When I take my plug-in out it starts most of the time).
My Question is how do I go about
debugging the WireShark.exe to find out where the fault address crash is ??
(1) –
Are there any log files or debugging info .??
(2) –
Do I use the Visual 2008 debugger – if so, Do I need to compile in debug
mode ??
I am not very familiar
with Visual 2008 – so any tips would be appreciated
Thanks
Patrick
**********************************************************************
SunGard Public Sector Limited, Methuen Park, Bath Road, Chippenham, Wiltshire SN14 0TW
Telephone: 08456 041999, Fax: 08456 052999
Registered Office: 25 Canada Square, London E14 5LQ. Registered in England No.
1593831 VAT Reg No. GB 810 9546 34
**********************************************************************
CONFIDENTIALITY: This e-mail (including any attachments) may contain confidential, proprietary and privileged information, and is intended solely for the use of the individual or entity to whom they
are addressed. Any unauthorized disclosure or use is prohibited. If you received this e-mail in error, please notify the sender and delete this e-mail from your system.
**********************************************************************
This message has been checked for all known viruses on behalf of SunGard Public Sector by MessageLabs.
http://www.messagelabs.com or Email: mailsweeper.info@xxxxxxxxxxxxxxxxxxx
For further information http://www.sungardps.co.uk
|