Hi Vaibhav,
I had the same issue then I put the libgtk-0.dll in the folder where the .exe file is situated.You can found it under ..\wireshark-win32-libs\gtk+\lib\.
Hope it will help.
best Regards.
Aziz
vaibhav.agarwal@xxxxxxxxxxx a �crit :
Hi,
I made new new wireshark.exe. If I run that exe it gives error "This
Application has failed to start because libgtk-0.dll was not found.
Re-installing the application may fix this problem".
But the original exe those comes with setup it works fine.
please tell what is the problem.
Thanks & Regards,
Vaibhav
*********************** Aricent-Unclassified ***********************
"DISCLAIMER: This message is proprietary to Aricent and is intended solely
for the use of
the individual to whom it is
addressed. It may contain privileged or
confidential information and should not be
circulated or used for any purpose other than for what it is intended. If
you have received this message in error,
please notify the originator immediately. If you are not the intended
recipient, you are notified that you are strictly
prohibited from using, copying, altering, or disclosing the contents of
this message. Aricent accepts no responsibility for
loss or damage arising from the use of the information transmitted by this
email including damage from virus."
_______________________________________________
Wireshark-dev mailing list
Wireshark-dev@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-dev
Ne gardez plus qu'une seule adresse mail !
Copiez vos mails vers Yahoo! Mail