Yes I did, it traces back to libpcap_open invalid address
then I use ldd /local/scratch/usr/local/bin/wireshark (where my wireshark is installed), it turns out
libwiretap.so.0 => /usr/lib/libwiretap.so.0 (0xb7f46000)
this is wrong, as I use ./configure --prefix=/local/scratch/usr/local, the libwiretap should points to /local/scratch/usr/local/lib/libwiretap.so.0 right?
How to fix this?
Thanks,
/Yin
On 6/18/07, Jaap Keuter <jaap.keuter@xxxxxxxxx> wrote:
Hi,
Can you run Wireshark in DDD so you can get a backtrace?
See http://wiki.wireshark.org/Development/Tips
Thanx,
Jaap
yin sun wrote:
> Hello,
>
> I have compiled wireshark from 0.99.5 source on Suse10 Linux
> 2.6.16.27-0.9-smp x86. Initial launch is ok, change/save preference is
> ok, but failed at displaying packet with Segmentation fault. When I
> tried the same pcap file with tshark, it is OK. So it must be some gui
> related problem. Can someone help me on this. How to proceed to find the
> problem.
>
> Thanks,
> /Yin
>
_______________________________________________
Wireshark-dev mailing list
Wireshark-dev@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-dev