Good deal.
I was a little surprised that you were having trouble, since I have seen
email from you about as long as I've been subscribed.
I've tried copying the CYGWIN setup from one machine to another (doesn't
work!). Had to reinstall CYGWIN!
-Tim
> -----Original Message-----
> From: wireshark-dev-bounces@xxxxxxxxxxxxx
> [mailto:wireshark-dev-bounces@xxxxxxxxxxxxx] On Behalf Of
> Jacques, Olivier (OpenCall Test Infra)
> Sent: Friday, September 08, 2006 5:08 AM
> To: Developer support list for Wireshark
> Subject: Re: [Wireshark-dev] win32: nmake setup: can't find cl
>
> Tim,
>
> Thanks for your answer.
>
> > Have you done the following:
> >
> > Do you intend to build using MSVC & CYGWIN tools?
> > Was your Win32 build environment setup using the Developers Guide,
> > sections 2.3 & 4.6.2?
>
> Yes.
>
> > If you intended to use MSVC & CYGWIN tools, a command prompt [DOS
> > prompt] is the way to go!
>
> This is what I was using (and I have been compiling
> Wireshark/Ethereal for over 2 years).
>
> > Also ensure that you have run vcvars32.bat before calling
> nmake. This
> > is normally in "Program Files\Microsoft Visual
> studio\VC98\bin". This
> > sets lots of important paths and env vars for MSVC6.
>
> This was done too.
>
> For the records, the issue vanished by re-installing cygwin
> from scratch (without any other change). Something was
> screwed up there.
>
> Thanks a lot for your help,
> Olivier.
> _______________________________________________
> Wireshark-dev mailing list
> Wireshark-dev@xxxxxxxxxxxxx
> http://www.wireshark.org/mailman/listinfo/wireshark-dev
>
> ______________________________________________________________
> _______________
> Scanned by IBM Email Security Management Services powered by
> MessageLabs. For more information please visit
> http://www.ers.ibm.com
> ______________________________________________________________
> _______________
>