great stuff.
thanks
On 6/30/06, Aaron Christensen <aaronmf@xxxxxxxxx> wrote:
Sure. Done:
http://wiki.wireshark.org/Network_Data_Management_Protocol
A couple of images of captured packets (including one that works after the
patch) and a sample packet capture. The NDMP client/server I was using had
some extensions not recognized, so there's some extra traffic that is
NDMP-ish in the capture.
~aaron
On 6/30/06, ronnie sahlberg <ronniesahlberg@xxxxxxxxx> wrote:
>
> ok,
>
>
>
> ill check it in in a few hours.
>
> by the way, do you have access to ndmp captures you can share and upload
> to the wiki page?
> we do not have any public sample captures of NDMP yet.
>
>
>
>
> On 6/30/06, Aaron Christensen <aaronmf@xxxxxxxxx> wrote:
> >
> > Hi, Ronnie,
> > I initally checked this against the specification for NDMPv2 and v4 to
> > make sure. In going back, I double checked with v2, and then check
against
> > v3, v4, and v5. It looks like the error field has been in there all
along
> > for NDMP_CONFIG_GET_AUTH_ATTR. I admit, I only have an implementation
for
> > NDMPv4, and since the specification for this message is unchanged it
seems
> > to me that other versions should be the same implementation-wise.
> >
> > Regards,
> > ~Aaron
> >
> >
> > On 6/29/06, ronnie sahlberg < ronniesahlberg@xxxxxxxxx> wrote:
> > >
> > > Can you check ndmp versions 2 to 5 that this is true for all
> > > versions of ndmp?
> > >
> > > if not you have to add a switch statement to manage the difference
> > > between versions.
> > >
> > >
> > >
> > > On 6/30/06, Aaron Christensen <aaronmf@xxxxxxxxx> wrote:
> > >
> > > > Added the dissection of a field that wasn't being picked up during
> > > NDMP MD5 authentication.
> > >
> > > The NDMP_CONFIG_GET_AUTH_ATTR message response was using the function
> > > dissect_auth_attr_msg() which dissects an auth_attr struct. However,
the
> > > specification includes and error field previous to that struct. Since
that
> > > function was being called directly, the error field was being picked
up as
> > > part of the auth_attr, and then leaving some extra data at the end.
> > >
> > > I added a new function, dissect_ndmp_config_get_auth_attr_reply(),
> > > which first calls dissect_error() and then dissect_auth_attr_msg(). I
> > > didn't change dissect_auth_attr_msg() because the
NDMP_CONNECT_SERVER_AUTH
> > > request uses it directly. After testing it, it appears to be picking
things
> > > up correctly, now.
> > >
> > > Regards,
> > > ~Aaron Christensen
> > >
> > > _______________________________________________
> > > Wireshark-dev mailing list
> > > Wireshark-dev@xxxxxxxxxxxxx
> > > http://www.wireshark.org/mailman/listinfo/wireshark-dev
> > >
> > >
> > >
> > >
> > >
> >
>