Comment # 27
on bug 9427
from [email protected]
Correction on T1 channel. Also regarding the secific T1 config (again?).
Next is to check the format of IETF Frame-Relay.
However, may I suggest the next development step be to simply decode to the
Frame-Relay level by following the boundaries of the T1 slots/channels Guisyus
indicated.
Serial2/0/2/16:0 is up, line protocol is up
Hardware is PMC FREEDM, PMC TEMUX, TDK LIU
Description: XXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXXX
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 2/255, rxload 2/255
Encapsulation FRAME-RELAY IETF, crc 16, loopback not set
Keepalive set (10 sec)
Carrier delay is 1 sec
LMI enq sent 0, LMI stat recvd 0, LMI upd recvd 0
LMI enq recvd 444451, LMI stat sent 444451, LMI upd sent 0, DCE LMI up
LMI DLCI 0 LMI type is ANSI Annex D frame relay DCE segmentation inactive
Broadcast queue 0/256, broadcasts sent/dropped 0/0, interface broadcasts 0
Last input 00:00:00, output 00:00:03, output hang never
Last clearing of "show interface" counters 7w2d
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 1216
Interface Serial2/0/2/16:0 queueing strategy: PXF Class-based
5 minute input rate 14000 bits/sec, 24 packets/sec
5 minute output rate 17000 bits/sec, 28 packets/sec
134994741 packets input, 2046097175 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicasts)
0 runts, 0 giants, 0 throttles
4 input errors, 0 CRC, 2 frame, 0 overrun, 0 ignored, 2 abort
151205504 packets output, 3073870503 bytes, 0 underruns
17 output errors, 0 collisions, 2 interface resets
0 output buffer failures, 0 output buffers swapped out
5 carrier transitions no alarm present
Timeslot(s) Used: 1-24, subrate: 1536Kb/s, transmit delay is 0 flags
non-inverted data
You are receiving this mail because:
- You are watching all bug changes.