| Bug ID |
8091
|
| Summary |
Allow/Create an option to use "capture filter" labels defined in wireshark GUI from CLI
|
| Classification |
Unclassified
|
| Product |
Wireshark
|
| Version |
unspecified
|
| Hardware |
All
|
| OS |
All
|
| Status |
UNCONFIRMED
|
| Severity |
Enhancement
|
| Priority |
Low
|
| Component |
Common utilities (libwsutil)
|
| Assignee |
[email protected]
|
| Reporter |
[email protected]
|
Build Information:
--
I am trying to launch wireshark from the cli with the following options...
wireshark -k -i eth2 -a filesize:1000000 -f <capture filter=""> The issue I
have is that I want to use a pre-defined wireshark filter... when I run the
above with the actual filter in the cli cmd it works, when I use a pre-defined
one it fails..
Working example:
wireshark -k -i eth2 -a filesize:1000000 -f "host 40.40.41.42" Failure example
(the one I am trying to use):
wireshark -k -i eth2 -a filesize:1000000 -f pre-defined-capture1 Where
pre-defined-capture1 filter does show up under "Capture -> Options -> Capture
Filter" list...
The error i get is that the filter is not valid, I would like to specify the
filter I saved in the capture filters list if thats possible...
You are receiving this mail because:
- You are watching all bug changes.