Wireshark-bugs: [Wireshark-bugs] [Bug 2361] New: Wireshark crashed when changing an option

Date: Fri, 14 Mar 2008 00:06:57 +0000 (GMT)
http://bugs.wireshark.org/bugzilla/show_bug.cgi?id=2361

           Summary: Wireshark crashed when changing an option
           Product: Wireshark
           Version: 0.99.7
          Platform: PC
        OS/Version: Windows XP
            Status: NEW
          Severity: Minor
          Priority: Low
         Component: Wireshark
        AssignedTo: wireshark-bugs@xxxxxxxxxxxxx
        ReportedBy: abennet1@xxxxxxxxxxx


Build Information:
Version 0.99.7 (SVN Rev 23910)

Copyright 1998-2007 Gerald Combs <gerald@xxxxxxxxxxxxx> and contributors.
This is free software; see the source for copying conditions. There is NO
warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.

Compiled with GTK+ 2.12.1, with GLib 2.14.3, with WinPcap (version unknown),
with libz 1.2.3, with libpcre 6.4, with SMI 0.4.5, with ADNS, with Lua 5.1,
with
GnuTLS 1.6.1, with Gcrypt 1.2.3, with MIT Kerberos, with PortAudio PortAudio
V19-devel, with AirPcap.

Running on Windows XP Service Pack 2, build 2600, with WinPcap version 4.0.2
(packet.dll version 4.0.0.1040), based on libpcap version 0.9.5, without
AirPcap.

Built using Microsoft Visual C++ 6.0 build 8804

Wireshark is Open Source Software released under the GNU General Public
License.

Check the man page and http://www.wireshark.org for more information.
--
I recorded a few (probably 10-20) seconds of packet data (on office LAN so
there was a fair amount of traffic).  I set an IP destination address filter. 
I changed the address.  I recorded a new log, again over several seconds
(roughly 30-60).  I started looking at the recorded data, and saw a message
about "TCP Checksum Offload."  I googled it and read this page:
http://wiki.wireshark.org/TCP_checksum_offload.  When I changed that setting,
Wireshark crashed.  Sorry, I've had a few interruptions since then, so I don't
remember _exactly_ when it crashed, but I _think_ it was when I pressed OK or
Apply.  The crash was the standard 'Windows has detected a problem, would you
like to tell Microsoft about it' and I answered no.  When I restarted Wireshark
to paste the Build Information into this bug report, I checked that value, and
it had was cleared (i.e. it must have been saved before Wireshark crashed).


-- 
Configure bugmail: http://bugs.wireshark.org/bugzilla/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are the assignee for the bug.