["Craig Wicker" <CWicker@xxxxxxxxxxxxxxxxxxx>]

 have a Dell 3024 switch, so I hope the answer isn't going to be that much off target.

When I log onto the switch, one of the choices I have at the main menu is 'Port Mirroring'.

When I select that menu, I am asked  to enter the 'source port' and the 'monitor port'.

I believe for your answer the 'source port' would be to identify port 5 and the monitor port is 11.

Mirroring is a toggle on/off choice using the spacebar when that choice is selected.

 

Next step: select the name of the network interface card (NIC) that is connected to port 11 on the switch; you will not see the port interface offered as a choice.

 

You should see a "mirror" image of all the traffic from port 5 send to port 11.

Craig Wicker
Systems Administrator
p:276.638.3020
440 E. Commonwealth Blvd
Hooker Furniture Corporation
Martinsville, VA 24112
www.hookerfurniture.com
Sniffer Certified Professional
CompTIA A+, N+
Microsoft MCP
Cisco CCNA
HP-UX
Be careful what you ask for;
you just might get it.

 

---

From: ethereal-users-bounces@xxxxxxxxxxxx [mailto:ethereal-users-bounces@xxxxxxxxxxxx] On Behalf Of ldo
Sent: Monday, July 11, 2005 3:20 AM
To: ethereal-users@xxxxxxxxxxxx
Subject: [Ethereal-users] Capture packets from other port of Dell SW3324-need help

Hi all,

 

I set up the port monitor for dell switch 3324, destination port 1/e11, source port 1/e5. I run ethereal on destination port 1/e11 and select Ethernet interface for capture (interfaces of source port 1/e5 not appeared)   but I did not receive any packets from source port 1/e5. I read through the documentation & FAQ and I did not find any answer. I need help. Any one has this problem before? And if I capture traffic on destination port I will receive all packets from destination and source ports at the same time?

 

Thanks in advance

 

Regards,

Lien Do