Hi All,
Im doing some network tests. I have (think I have) set up my routes so that any
udp packets that I send to the localhost are sent to the network rather than
the loopback address.
When Im checking for these packets - they appear as DCERPC DCE/RPC fragments!
Is this reasonable?
Do you think that I have set up the routing tables properly!
If not - does anyone know how I can configure the routes so that the loopback is
disabled?
C:\Documents and Settings\ME>route print
===========================================================================
Interface List
0x1 ........................... MS TCP Loopback interface
0x2 ...00 11 43 aa be 6b ...... Broadcom NetXtreme 57xx Gigabit Controller -
Pac
ket Scheduler Miniport
===========================================================================
===========================================================================
Active Routes:
Destination Netmask Gateway Interface Metric
0.0.0.0 0.0.0.0 AAA.BBB.CC.1 AAA.BBB.CC.ME 20
127.0.0.0 255.0.0.0 127.0.0.1 127.0.0.1 1
AAA.BBB.CC.0 255.255.255.0 AAA.BBB.CC.ME AAA.BBB.CC.ME 20
AAA.BBB.CC.ME 255.255.255.255 127.0.0.1 127.0.0.1 20
AAA.BBB.CC.ME 255.255.255.255 AAA.BBB.CC.1 AAA.BBB.CC.ME 1
224.0.0.0 240.0.0.0 AAA.BBB.CC.ME AAA.BBB.CC.ME 20
255.255.255.255 255.255.255.255 AAA.BBB.CC.ME AAA.BBB.CC.ME 1
Default Gateway: AAA.BBB.CC.1
===========================================================================
Persistent Routes:
Network Address Netmask Gateway Address Metric
AAA.BBB.CC.ME 255.255.255.255 AAA.BBB.CC.1 AAA.BBB.CC.ME 1
Any help on this is greatly appreciated - cos its been wrecking my head for a
few days now!
Thanks - kind regards,
Nikki
----------------------------------------------------------------
This message was sent using IMP, the Internet Messaging Program.