Thanks, it worked after I disabled the ENIP.
Bilig
-----Original Message-----
From: martin.regner@xxxxxxxxx [mailto:martin.regner@xxxxxxxxx]
Sent: Tuesday, September 30, 2003 8:02 PM
To: boyun@xxxxxxxxxxx; ethereal-users@xxxxxxxxxxxx
Subject: Re: [Ethereal-users] H225 message decode error
Bilig Oyun wrote:
>
> I have run into a problem where some versions (including the latest) of
the
> Ethereal can't decode some H225 signaling messages, such as setup,
alerting
> and release complete.
>
> I have tried the same trace on 0.9.12 (with h323 plugin), 0.9.13 (with
h323
> plugin), and 0.9.15 and only the 0.9.12 version is able to decode the h225
> correctly. On the other two versions, the Ethereal will display "ENIP
> Response: Unknown Command (3), Session = xxxxxxx" for the setup message.
>
> Attached is the trace.
>
> pkt # 4: setup
> pkt # 5: proceeding
> pkt # 7: alerting
> pkt # 9: release complete
>
>
I have not been able to look on your capture since I´m on an internet-cafe
right now, but I expect that you can get it working by disabling ENIP
protocol.
I had some similar problem before with H.323 packets being shown as ENIP.
Disable ENIP :
Edit../Protocols/
Mark the ENIP line in the list so that it is shown as "Disabled" + Apply +
Save + OK.