Bilig Oyun wrote:
>
> I have run into a problem where some versions (including the latest) of the
> Ethereal can't decode some H225 signaling messages, such as setup, alerting
> and release complete.
>
> I have tried the same trace on 0.9.12 (with h323 plugin), 0.9.13 (with h323
> plugin), and 0.9.15 and only the 0.9.12 version is able to decode the h225
> correctly. On the other two versions, the Ethereal will display "ENIP
> Response: Unknown Command (3), Session = xxxxxxx" for the setup message.
>
> Attached is the trace.
>
> pkt # 4: setup
> pkt # 5: proceeding
> pkt # 7: alerting
> pkt # 9: release complete
>
>
I have not been able to look on your capture since I�m on an internet-cafe right now, but I expect that you can get it working by disabling ENIP protocol.
I had some similar problem before with H.323 packets being shown as ENIP.
Disable ENIP :
Edit../Protocols/
Mark the ENIP line in the list so that it is shown as "Disabled" + Apply + Save + OK.
Dear Ethereal
Developers,
I have run into a
problem where some versions (including the latest) of the Ethereal can't decode
some H225 signaling messages, such as setup, alerting and release
complete.
I have tried the
same trace on 0.9.12 (with h323 plugin), 0.9.13 (with h323 plugin), and 0.9.15
and only the 0.9.12 version is able to decode the h225 correctly. On the other
two versions, the Ethereal will display "ENIP Response:
Unknown Command (3), Session = xxxxxxx" for the setup
message.
Attached is the
trace.
pkt # 4:
setup
pkt # 5:
proceeding
pkt # 7: alerting
pkt # 9: release
complete
Thank you,
Bilig Oyun
Attachment:
H225-setup-decode-error
Description: Binary data
_______________________________________________
Ethereal-users mailing list
Ethereal-users@xxxxxxxxxxxx
http://www.ethereal.com/mailman/listinfo/ethereal-users