Dear All,
I need to decode FCP for our SAN. I have ethereal installed and have
used it for ethernet but how do I get it to see the Fibre Channel Card
so I can select that to capture packets on. I have Red Hat 8 with an
emulex LP9002L card installed. The card works fine as we have a disk
mounted over the SAN using the card.
Yours sincerely
David Ruwoldt
--
David Ruwoldt
Team Leader, Operating Systems & Services
Information Technology Services
Level 7, 10 Pulteney St
ADELAIDE UNIVERSITY SA 5005
AUSTRALIA
-----------------------------------------------------------
This email message is intended only for the addressee(s)
and contains information which may be confidential and/or
copyright. If you are not the intended recipient please
do not read, save, forward, disclose, or copy the contents
of this email. If this email has been sent to you in error,
please notify the sender by reply email and delete this
email and any copies or links to this email completely and
immediately from your system. No representation is made
that this email is free of viruses. Virus scanning is
recommended and is the responsibility of the recipient.