["Allan Silverstein" <allan@xxxxxxxx>]

How would I go about using Ethereal to capture ATM traffic.  For example if
I had a Cisco router with an ATM interface connected to an ATM switch and I
wanted to see the traffic between the two.  If I were using a Network
General Sniffer of HP's Internet Advisor, I could put their sniffer
"in-line" beween the Router port and ATM switch port and capture traffic.
How would I go about doing that with Ethereal.  If this is possible, I know
I would need an ATM NIC card (dual port???).  Where would I go from there??
Special drivers, etc, etc????

Thanks
al silverstein