Hi Jasim,
if you want to run ethereal directly from the source directory, you
should do a "nmake install-deps" after building ethereal. This will copy all
required libraries to the source directory and the official plugins to
the appropriate location, ($ethereal_mainsource_dir)/plugins/0.10.14/ in your
case.
You have to copy your own plugins manually into this directory or you have to
add such code to the install-plugins target in plugins/Makefile.nmake.
Note, that the gtk2 version of ethereal is called ethereal-gtk2.exe within
the source tree.
Regards,
Lars
Am 27.01.2006, 23:03 Uhr, schrieb Jasim Tariq <jasimtariqjt@xxxxxxxxxxx>:
Hi,
I have built ethereal under windows environment. Only trouble is that when
I go to Analyze --> Enabled Protocols, there are no plugins listed. However
I have tried using a single setup file for windows. Now when I look at
enabled protocols, I find all the plugins listed. Why are the plugins not
installed when I use the sourse code to build ethereal under windows
environment.
I want to build ethereal because I want to add some dissector plugins to
it. Any suggestions.....?
Thanks
Jasim
_______________________________________________
Ethereal-dev mailing list
Ethereal-dev@xxxxxxxxxxxx
http://www.ethereal.com/mailman/listinfo/ethereal-dev